This video is for eBay purposes to show this VSV work idling up the engine idle speed when the AC is turned on.

4. With solenoid energized, open throttle slightly and plunger will extend. Release throttle and adjust to desired RPM by turning hex head on plunger counter-clockwise to increase RPM and clockwise to decrease. When solenoid is de-energized plunger will retract. Technical Support: 1-270-781-9741 199R11438 Date: 10-27-17 3 2 1 4 3 2 1 4

\n \n\n \n how to adjust ac idle up
Holley, Edelbrock, Carter and Rochester carbs all have remarkably similar tuning procedures. Here's an easy guide to setting their idle speed and fuel mixtu
Fast idle speed is set up on the second step of the cam, about 1300 is good. Make sure your Ruggles choke pulloff is still operating correctly, make sure it hold vac, and still releases at that 2 or so seconds and just doesn't pop out. Make sure you still have 12vdc supplied to the choke. Normal setting for a GM choke coil is about level
Holley Idle Speed Adjustment Instructions: Once the engine is up to operating temperature, the idle speed can be set to what was configured in the Wizard. To do this, open up the Initial Startup gauge screen that was used in section 17.0. With the vehicle in neutral, adjust the idle screw until the IAC Position reads between 2 and 10%.

Over time, the contacts wear out and the switch must be replaced for the AC to function. When the clutch switch has failed, it will usually produce a few simple symptoms to look out for. 1. Lack of cooling. If you begin to notice that the AC system is not blowing as cold as it used to, then that may be a sign that the switch has failed, or is

rebFK0Y.
  • lp5hwrs0ay.pages.dev/276
  • lp5hwrs0ay.pages.dev/506
  • lp5hwrs0ay.pages.dev/497
  • lp5hwrs0ay.pages.dev/533
  • lp5hwrs0ay.pages.dev/439
  • lp5hwrs0ay.pages.dev/183
  • lp5hwrs0ay.pages.dev/207
  • lp5hwrs0ay.pages.dev/486

    • how to adjust ac idle up